Road-armor 2010+ Dodge 2500,3500 Front Bumper Manuel d'utilisateur télécharger pdf

Warning!

Read the instructions completely before beginning the installation. Before tightening bolts, drilling or

cutting where required, check to make sure that there are no obstructions such as brake, fuel or electri-

cal lines that may be damaged. Also keep in mind this is an aftermarket product and MAY require some

minor shimming and or trimming, reaming etc. to t properly.

IMPORTANT NOTICE

IF YOU ARE RECEIVING THIS ROAD ARMOR PRODUCT RAW/UNCOATED.

BE SURE TO INSPECT AND OR TEST FIT YOUR PRODUCT TO ENSURE PROPER FITMENT AND ADEQUATE SURFACE PREPARATION BEFORE

HAVING YOUR PRODUCT COATED, PAINTED, BED LINED, ETC.

ROAD ARMOR WILL NOT BE RESPONSIBLE FOR THE COST OF COATING YOUR UNIT IF ANY PROBLEMS WITH FIT OR FINISH ARE NOT

NOTED AND ADDRESSED PRIOR TO HAVING YOUR PRODUCT COATED.

THANK YOU

SUGGESTED LIGHTS THAT FIT THIS UNIT:

PIAA 510 - www.piaa.com - Part Numbers (5161, 5164, 5192, 5190, 5196).

Warn 350F - www.warn.com Part Number (82410).

TOOLS NEEDED

-Yourself and a strong friend / bumper jack.

( Don’t worry, we’re not calling you or your friend a “tool” )

- Socket set, Ratchet & Wrenches (metric & standard)

( ... more than likely metric for your rig, cause everything’s imported these days,

and standard for your new bad ass Made in USA bumper.

Road Armor thanks you for supporting the American Economy! )

- You may need a Sawzall if your truck is diesel.

- Common Sense a Tape Measure and a bit of Patience.

( And also a cold drink to celebrate afterwards )

2010+ Dodge

Ram 2500/3500

Front Bumper

Install

Instructions

1 2 3 4 5 6

Résumé du contenu

Page 1 - Instructions

Warning! Read the instructions completely before beginning the installation. Before tightening bolts, drilling or cutting where required, check to mak

Page 2 - STEP 3:

STEP 1 : Make sure you have all necessary tools and hard-ware. Hardware Kit Includes : ( all Grade 8 ) (8) Single Bolt Plates (8) ½” Push On Ret

Page 3 - STEP 4:

STEP 4: • Install the rst Road Armor frame bracket using stock hardware. Refer to picture to determine how the bracket mounts onto the frame. Hand t

Page 4

11121098Repeat this step for the other side of the bumper. Hand tighten all hardware to allow for adjustment at a later step.• Insert the four other

Page 5 - DIESEL TRUCK INSTRUCTIONS

DIESEL TRUCK INSTRUCTIONS• The reason it takes additional procedures is because the intercooler is in the way from getting the bolt plate out. • Sta

Page 6

• Install the winch to the bumper using the supplied Allen Bolts and Washers. Note - Install the Flairlead bolts before you mount the winch.192021

Commentaires sur ces manuels

Pas de commentaire

Road-armor 2010+ Dodge 2500,3500 Front Bumper Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Road-armor 2010+ Dodge 2500,3500 Front Bumper. Road Armor 2010+ Dodge 2500,3500 Front Bumper User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Road-armor 2010+ Dodge 2500,3500 Front Bumper